Here it is....
The all new 35 Amp HD-PWM
in a box with fan and
Free Shipping
This HD-PWM will meet the needs of most all single
and double cells used for hydrogen boosting and
is made to be superior to the popular 30 amp Max
066 PWM.
Features:
*
New - Frequency adjustment...
100 Hz fixed or 300-3,000 Hz adjustable
* New - More powerful output transistors
* New - 8 on board male spade connectors
for better power transfer
* New - Larger heat sinks
* New - Wire re-enforced circuit board traces
* New - Larger mosfet pre driver
* New - Power LED
* New - Wide operating range 8-30 volts
(fan is rated
for 10-18 volts)
You
are buying a new 35 Amp HD-PWM with Box Fan + knobs
and a 30 day exchange warranty.
You will need to add a relay and wire. We recommend
10-12 gauge wire and it is best to use all 8 spade
connectors.
With
a Pulse Width Modulator, your HHO booster will run
cooler and make more monoatomic hydrogen than just
using direct current alone. Monatomic hydrogen
has a greater ability to increase fuel mileage than
diatomic (REG) hydrogen.
If
your cell makes 1 LPM at 17 amps with a PWM you
can set the pulse width to 50%-60% and the current
will be about 9-10 amps and still produce about
the same volume of HHO but the HHO will be of a
higher quality. If you want to use more current
you can use a slightly stronger electrolight (Not
more than 20%)
At
this low current level, you can now run 2 cells
on about the same amount of power you used to use
with just 1 cell.
TECHNICAL
SPECIFICATIONS:
*
Operating Voltage: 8-30 VDC
* Max current load: 30-35 amps RMS
* Peak current load: Over 50 amps
* Output type: Pulse Width Modulation
(for controlling DC loads)
* Pulse Width: Adjustable from 0% to 100%
* Output frequency: 100 Hz fixed or 300 - 3,000
Hz adjustable.
* Box dimensions: aprox. 5 x 3 x 2.5
This
unit is fully tested and ready to be installed Guaranteed
No DOA
30 day warranty:
If this HD- PWM fails within 30 days we will replace
it at no cost to you.
You will need to pay for shipping to us.
We will not replace the PWM if you connect the +
and - wires backwards and burn out the reversing
diode.
Free shipping is for the USA only
If you are not in the USA please send us E-mail
35 amp PWM with box and fan
Only
$69.00
with free shipping in the USA
|
Lot of (3) 35 amp PWM's with box,fan and free
shipping
Only $189.95
|
35 amp PWM with box, fan and World Wide
Shipping
Only
$84.95
|
Click for larger image
